Continuous Monitor Parts
A. Mat Monitor Switch: Use a probe to access the mini slide switch. Slide the switch to the right to enable the mat monitor circuit. Slide the switch to the left to disable the mat monitor circuit. This switch is enabled as default.
B. Buzzer Volume Adjustment: Turn the trimpot clockwise to increase the buzzer volume. Turn the trimpot counter-clockwise to decrease the buzzer volume.
C. Monitored Operator Jack: Insert the single-wire wrist cord here to monitor the operator’s connection to ground.
D. Operator LEDs: Illuminates green when the operator is properly grounded. Illuminates solid red and audible alarm sounds when the operator is not properly grounded.
E. Mat LEDs: Illuminates green when the worksurface is properly grounded. Illuminates red and audible alarm sounds when the worksurface is not properly grounded.
F. Park Snap: Allows the operator to disconnect (and park) a wrist strap when leaving the workstation, without creating a false alarm. Touch the park snap and the monitor’s audible alarm will disable for approximately 10 seconds.
Use this time to disconnect the coil cord from the wrist strap, and attach it to the park snap or remove the coil cord from the monitor. Upon returning to the workstation and disconnecting the coil cord from the park snap, the operator has approximately 10 seconds to reconnect the coil cord to the wrist strap before activating the alarm.
G. Mat Monitor Screw Terminal: Verifies that the worksurface’s path-to-ground is <10 megohms. Connect the white mat monitor cord here.
H. Power Jack: Connect the included 24VDC power adapter here.
I. Remote Alarm Jack: Connects to the 19653 Remote Alarm accessory.